leshantir Posted August 30, 2015 Posted August 30, 2015 Hi there. My model is based on a vehicle assembly line and when running experiments I have kept all factors constant except for part entities per arrival. Up until a certain number (9 entities per arrival) the experiments run in a few minutes (with 10 replications) however anything greater than that causes the experiments to take hours to run just 1 replication. No warnings have come up for too many entities present in the system or anything like that. What could be the possible causes for this?
MEagar Posted August 30, 2015 Posted August 30, 2015 Sounds like somewhere in your logic an infinite loop is prevailing.
dsturrock Posted August 30, 2015 Posted August 30, 2015 I would try running those exact parameters interactively. The animation or trace should give you a better idea where the problem occurs. If the problem is not obvious, you might also enable runtime profiling (Run ribbon > Advanced Options).
Recommended Posts